Replaced the oven igniter. I used a string attached to the connectors, wrapped the string and connectors with electrical tape to do as little damage to the insulation, and pulled out the igniter from inside the oven. Once the string was pulled into the oven, the old igniter was cut off and the new igniter was tied at the connectors. Electrical tape was then wrapped around the string, connectors, and the thermal wire insulation to prevent catching the oven insulation. Pulled the new igniter wires from the back of the stove with the string, took off the string and electrical tape, and connected up the new igniter. Tested by holding in the door shut switch button with tape and turning on the oven. It worked! Turned off the oven, and put it back together.