House Tech October 30, 2022 for Model Number Dw80f609utw-aa Is there a remove/install video with this circulation pump? I want to know what I am in for before I purchase. Thanks
Mike July 29, 2019 for Model Number DW80F600UTS/AA-0000 Recently had a code for water in the pan. Removed pan and found a small amount of water that seemed to coming from around or inside the recirculation pump. My guess is that the shaft seal is bad? When I cleaned it up and ran through a cycle I now notice the pump seems louder, like a grinding or whirring noise that wasn't there before. This is all strange because the dishwasher is only 2-1/2 years old. Before I order a new pump, I'm just curious if a water leak around the seal would cause a pump to become noisy like that.
1 Answer Mike, Yes, a leaking seal could cause an issue with the unit that would cause the dishwasher to make a louder than normal noise. Read More...
1 Answer Ben, Check to see if there is 120 vac getting to the water valve and if there is then this will most be a faulty water valve on the unit. Read More...
Robert January 06, 2019 for Model Number SAMSUNG DW7933LRABB/AA Dishwasher making a grinding noise from start to finish
1 Answer Robert, You will want to check the wash motor to make sure that the noise is not coming from it. Check to make sure that there is nothing caught in the pump. If there is nothing in the pump then the pump would be the most likely issue. Read More...
Michael May 20, 2018 for Model Number DW80J3020US/AA Washer seems to operate OK except when cycle finished you can feel and hear a humming from the bottom of the drain area. Putting your finger on the drain you can feel a small motor running and it does not stop unless I disconnect the power. Does not sound like the pump, what do you think would cause this? Bought May 14, 2017 but not installed until August 16, 2017.
1 Answer Hello Michael. You will want to check and make sure the float is not stuck and the unit is not leaking water. If not, then it sounds like the main control board DD82-01247A has failed and will need to be replaced on the unit. Read More...
Dan October 24, 2016 for Model Number DMT400RHS/XAA Can the capacitor that comes with the circulation motor be purchase separately?
1 Answer Sorry Dan. You will need to order the kit for the capacitor for the unit. It is not available separately. Read More...
Kenny October 23, 2016 for Model Number DMT800RHS/XAA Do you sell the capacitor only for the circulator motor? I believe the motor part number is AP5272861 Thank you.
Rob F September 26, 2016 for Model Number dw7933lrasr How can you check the circulating motor. What wires are what?
1 Answer Rob, You would test at the main control board from the CN201 connector Pin number 7 (Blue wire) to CN101 pin 3 yellow wire. There is also connector 201 pin 9 (white) to the CN101 Pin 3 that you would want to check. Read More...
Patrick February 11, 2013 Does the sump assembly part number AP4982351 come with a circulating pump motor?
1 Answer Hello Patrick. The sump assembly includes the circulating pump as an assembly. Thanks! Read More...