Ccf16w Parts

Freezer won't turn on or keeps tripping? This circuit breaker protects your appliance from electrical overload. Simple 10-15 minute fix for most models.

Fix a freezer that won't start or runs hot with this run capacitor. Helps the compressor motor start and run efficiently. Moderate DIY repair.

This kickplate grille covers the lower front opening of the oven cabinet, protecting internal components and directing vent airflow while maintaining a finished look for the range. Restores proper vent appearance and protects against debris. What it does:

• Covers the lower front vent opening and channels airflow from the oven cavity
• Protects internal components from dust, debris and accidental contact
• Replaces cracked, bent or missing kickplate trim that affects appearance
• Helps maintain proper ventilation clearance at the oven base

• One kickplate grille

• Disconnect power to the appliance before beginning work
• Remove the lower access drawer or panel per your manual to access mounting points
• Align grille tabs or screw holes, then secure with the factory fasteners (do not overtighten)

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary

Outer door panel for upright freezers. Replaces damaged, cracked, or dented exterior door panels. Restores the appearance and structural integrity of your freezer.

If your freezer display is blank, buttons don't respond, or temperature won't adjust, this electronic control board restores console function and control.

Foam insulation sleeve that wraps around the defrost drain tube. Replace if worn, missing, or damaged to prevent condensation and maintain proper insulation.

Replacement spacer for the front of the top grid in your freezer. Needed when original spacer is cracked, broken, or missing to properly support shelf.

Replacement control housing cover for freezers. Snaps over the control panel assembly. Replace if cracked, broken, or missing to restore appearance.

Main wiring harness that routes power between your freezer's control board and components. Replace if wires are frayed, connectors damaged, or harness worn.

Cabinet corner trim piece for freezers. Covers and finishes the corner edge of the cabinet exterior. Replace if cracked, chipped, or missing.

Rubber grommet for freezers. Cushions and seals components where wires or tubes pass through panels. Replace if cracked, worn, or missing.

This inner door panel replaces the damaged or missing interior surface of an oven door to restore safe heat containment and a finished appearance. It provides a durable inner barrier between the oven cavity and the outer door assembly. What it does:

• Forms the interior surface of the oven door to help contain heat and protect insulation and components.
• Restores a flat, intact inner surface when the original panel is cracked, dented, or warped.
• Helps stop drafts, rattling, and debris from entering the door cavity.
• Improves door appearance when the inner panel is visibly damaged or stained.

• One inner door panel

• Disconnect power to the appliance before beginning any repair; work only on a cool oven.
• Door removal and reassembly may be required; retain all screws and brackets and follow the oven manufacturer's service instructions.
• Handle panel edges and any glass with care—use gloves and eye protection to avoid cuts.

Replace your freezer door gasket to restore proper sealing and prevent frost buildup. Install when you notice air leaks or condensation. Confirm fit with your model.