Cm302ub Parts

A small retaining clip that secures a detent or pivot pin in place, keeping linked components aligned and preventing pins from slipping out during regular use. Restores proper retention for worn or broken clips. What it does

• Holds a detent/pivot pin in position so moving parts stay aligned
• Prevents pins from backing out, which can cause loose or misaligned doors/drawers
• Helps stop rubbing, rattling, or intermittent engagement caused by a missing clip
• Used wherever a small spring/retaining clip is required to secure a pin or shaft

• One detent pin retaining clip

• Simple replacement; access requires removing the panel or component holding the pin
• Use needle-nose pliers for safe, controlled installation of the clip onto the pin
• Power off and disconnect the appliance before servicing to avoid injury
• If the pin or mating parts are damaged, replace those components to ensure secure fit

This is a flat metal washer sized to fit 1/4" bolts and fasteners, providing a stable bearing surface to protect parts and distribute load for appliance assemblies. It helps restore secure, vibration-resistant connections. What it does:

• Provides a smooth bearing surface under heads or nuts to prevent wear and pull-through
• Distributes clamping force to reduce stress on mounting holes and thin materials
• Helps maintain tight fastener fit and reduces loosening from vibration
• Useful where precise spacing is needed between components

• Disconnect power and water to the appliance before accessing internal components
• Use the correct bolt/shaft diameter (1/4") and seating to avoid misfit
• Inspect mating surfaces and replace any damaged fasteners or hardware
• Tighten fasteners to secure fit but avoid excessive torque that can deform the washer

This wire harness assembly connects and routes power and signals between the appliance control and key components, with an integrated capacitor and diode to help suppress electrical noise and ensure correct operation. Replacing a damaged harness restores reliable power delivery and signal integrity. What it does:

• Provides electrical connections between the control board and components
• Integrated capacitor and diode help filter interference and protect circuits from voltage spikes
• Restores consistent power flow to eliminate intermittent operation or control faults
• Commonly replaced when wiring is frayed, burned, or connectors are damaged

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Handle connectors carefully; match connector orientation and fully seat each plug
• Route and secure the harness to prevent contact with hot surfaces or moving parts
• Observe basic ESD precautions when working near electronic control boards

This wire harness connects the appliance's stirrer assembly to the main wiring, restoring reliable electrical connection so the stirrer can operate as intended. It's a direct-fit replacement when the original harness is damaged or fails. What it does:

• Routes power and signal connections to the stirrer assembly so the motor/agitator can run
• Replaces frayed, burned, or broken wiring that causes intermittent or no stirrer operation
• Helps stop flickering, sparking, or loss of function caused by damaged connectors or wires
• Maintains correct connector pinout and wire routing for proper operation

• One replacement wire harness (stirrer)

• Disconnect power to the appliance before beginning any repair
• Inspect connectors and routing; match harness connectors to existing terminals before installation
• Use proper fasteners and routing clips to avoid pinched wires or contact with hot/moving parts