Efme427uiw1 Parts

The Lint Filter Kit is an OEM component specifically designed for Frigidaire clothes dryers. This kit includes both the main lint filter that collects lint and debris during the drying cycle, as well as the installed mesh screen filter component. These filters play a crucial role in protecting the dryer by trapping lint and preventing clogs in the ventilation system. 

Causes of a bad lint filter kit include excessive lint buildup that blocks airflow, physical damage to the mesh screen or filter housing, or missing components.

Symptoms of a bad lint filter kit include: 

• Slow or prolonged drying times 
• Excessive noise or vibration during operation
• Reduced airflow and ventilation in the dryer
• Lint accumulating in the ventilation duct

This OEM Frigidaire replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models. 
 

This vane screw secures the internal drum baffle (vane) to the drum, keeping loads turning properly and preventing rattles or snags. Replace a missing or stripped screw to restore a tight, stable baffle during cycles.

• Fastens the drum baffle/lifter (vane) to the rotating drum
• Helps maintain proper tumble and load turnover
• Common symptoms: loose or wobbly baffle, rattling or clunking noises, items catching on a raised baffle edge, or a baffle that detaches
• Visual cues: missing screw or stripped/damaged threads at the baffle mounting holes

• Disconnect power before servicing; shut off gas
• Access the baffle from inside the drum; align holes and start the screw by hand to avoid cross-threading
• Tighten firmly but do not overtighten to prevent stripping the drum or cracking the baffle
• Start all screws before final tightening to seat the baffle evenly

Secures the dryer motor in proper position for stable operation. Replace if motor shifts, buzzes, or clamp strips out. Confirm fit with your model number.

Washer that fits between the support roller and shaft in your dryer. Replace if worn, cracked, or missing to maintain proper drum alignment and support.

Small spacer that fits on the idler assembly shaft to properly align the belt tensioner. Replace if worn, cracked, or missing to maintain proper spacing.

If your dryer runs too hot, won't heat properly, or shuts off unexpectedly, the inlet thermistor may have failed. This sensor monitors incoming air temperature.

Replace your dryer seal to prevent air leaks, heat loss, and moisture escape. Restores tight barrier for efficient drying. Check fit with your model.

Dryer not heating properly or overheating? The thermistor monitors temperature and signals the control board. Common DIY repair, takes 15-30 minutes.

Replacement mounting screw for dryers. Secures panels, brackets, and internal components. Replace if stripped, missing, or corroded during repairs.

Dryer not starting or power cutting out? A melted or corroded terminal block disrupts power flow. This 3-terminal block restores secure connections. DIY-friendly repair.

Secures hose connections in dryers to prevent leaks and maintain proper airflow. Replace if hoses are loose or disconnected. Verify fit with model.

Clear outer window for dryer doors. Provides visibility into the drum during operation. Replace if cracked, scratched, or broken for safety and aesthetics.

Dryer door won't stay closed or latch properly? This door latch assembly secures your dryer door during operation. Simple DIY fix with just two screws.

Seals your dryer door to prevent heat loss and improve drying efficiency. Replace if stretched, collapsed, or air is escaping. Verify fit with model.

Replacement nut that secures internal components in dryers. Restores clamping force when original nut is stripped, worn, or missing. Prevents loosening.

Dryer not starting or shutting off mid-cycle? A faulty wire harness disrupts electrical signals to motors, heating elements, and controls. Moderate DIY repair.