Fggh3047vfb Parts

This replacement door cap is the molded end cap that finishes and protects the edge of a refrigerator door, restoring a clean appearance and covering exposed hardware. It helps keep the door trim sealed and cosmetically intact. What it does

• Covers and protects the exposed door edge and hinge area from damage and wear
• Restores a finished, factory appearance when the original cap is cracked or missing
• Helps prevent dirt and moisture from collecting in the exposed trim area
• Reduces rubbing or misalignment caused by damaged door trim

• One door cap/end cap

• High-level, snap-on or screw-retained installation; follow the manufacturer's diagram for the correct orientation
• Remove the door or hinge only if required by the manufacturer's instructions
• Disconnect power to the appliance before working near electrical components or removing door-mounted controls
• Use basic hand tools and take care not to scratch painted surfaces during installation

This insulation panel fits inside the refrigerator cabinet to help maintain interior temperatures and reduce heat transfer to the outer shell, supporting more consistent cooling and helping limit frost buildup. What it does:

• Forms a thermal barrier between the interior liner and outer cabinet to help hold cold air inside.
• Helps reduce frost and moisture buildup around the liner when intact.
• Worn, torn, or missing insulation can contribute to longer run times, uneven cooling, or more frequent defrost cycles.
• Replaces damaged insulation to restore proper temperature retention and improve appliance efficiency.

• Always disconnect power to the appliance before starting any repair.
• Panel may be secured with clips, adhesive, or foam sealant; remove and install carefully to avoid damaging the liner.
• Inspect surrounding seals, gaskets, and fasteners while accessing the cavity; replace any damaged components.

Note: ONE screw only, order as needed.

Size: 8-18ab x 0.5 inch.

The Control Panel is an OEM part for Frigidaire gas ranges. It is the area that allows you to control and adjust the various functions of your gas range.

A bad control panel can be caused by electrical issues, component failure, or physical damage. Signs of a faulty control panel include unresponsive buttons, malfunctioning knobs, or the inability to adjust the temperature or burner settings.

Symptoms of a bad control panel include:

• Unresponsive buttons or knobs on the control panel
• Inability to adjust temperature or burner settings
• Scratches, dents or other damage 

Replace your faulty or damaged control panel with this genuine OEM part to restore your gas range. This Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.
 

A replacement protective cover that shields internal components from heat, debris and accidental contact to help maintain safe, reliable operation. Simple, direct replacement when the original shield is damaged or missing. What it does:

• Covers and protects wiring, terminals or nearby components from heat and debris
• Helps prevent direct contact that can cause shorting, charring or other damage
• Reduces risk of noise from loose or rattling components when intact
• Restores the intended physical barrier for safe appliance operation

• Disconnect power to the appliance before inspecting or replacing this part.
• Handle edges carefully; the metal can be sharp. Use gloves and basic hand tools.

This metal shield protects internal components from heat, debris, and wear, helping the appliance run safely and reliably. It replaces damaged or missing shields to restore proper protection around sensitive parts. What it does:

• Shields wiring and components from heat and debris to prevent damage
• Helps reduce risk of shorting or component exposure caused by a damaged panel
• Common symptom: visibly bent, warped, or corroded shield
• Common symptom: unusual odors or hot spots near the area the shield covers

• One replacement shield/trim panel as shown

• Disconnect power (and gas supply if applicable) before starting any repair
• Wear gloves to protect against sharp sheet-metal edges
• Retain and reuse original fasteners when possible; replace any stripped screws
• If accessing the shield requires removing other panels, keep track of hardware and order of removal