Gfe28gynbfs Parts

Ice maker stopped working or making noise? This wiring housing protects ice maker wires from damage in your freezer. Prevents wire chafing issues.

Holds and positions refrigerator drawer or shelf dividers to keep contents separated. Replace this molded plastic stop if cracked, broken, or missing.

Replace a cracked or missing control board cover to protect electronics from moisture and dust. Simple snap-on installation takes 10-15 minutes.

This deli pan top rear cover replaces the rear trim piece on the deli/warming top, restoring a finished appearance and protecting internal components from food, grease and spills. Keeps the deli area sealed and easier to clean. What it does

• Covers and protects the rear edge of the deli/warming pan top assembly.
• Shields wiring and internal components from food debris and grease buildup.
• Restores a proper fit and finish when the original rear trim is cracked, broken or missing.
• Helps maintain a clean, hygienic deli surface and simplifies wiping and maintenance.

• One deli pan top rear cover.

• Disconnect power to the appliance before beginning any service.
• Removal may require releasing clips or removing a few screws; keep hardware for reassembly.
• Handle the cover gently to avoid cracking; align tabs/clips before seating.

Leveling leg screw assembly for bottom-mount refrigerators. Installs at the base to adjust height and stability. Replace if broken, stripped, or missing.

Upper freezer divider stopper for bottom-mount refrigerators. Secures the divider shelf in place. Replace if cracked, broken, or missing to restore organization.

Adhesive foam gasket that seals gaps between panels and components to reduce air leaks and vibration. Replace when worn or compressed to restore efficiency.

Fix water dispensing issues with this refrigerator water valve cover and tank assembly. Addresses leaks and flow problems. Moderate DIY repair.

Right-hand side support bracket for bottom-mount refrigerators. Replaces broken, cracked, or missing structural support. Installs on interior side.

This SCR (silicon controlled rectifier) controls high-current switching in the appliance's power circuit to enable reliable on/off control of heating or motor circuits. Designed for direct replacement of the original SCR component. What it does:

• Acts as a solid-state switch to control power to heating elements or motors when triggered by the appliance control board.
• Helps regulate current during start-up and run cycles to maintain proper operation of the appliance.
• Failures can cause symptoms such as no heat, intermittent operation, or the appliance not powering its load.
• Matches the OEM mounting and stud terminal configuration for proper electrical connection.

• One SCR component (8-32 stud) as pictured.

• Disconnect power to the appliance before servicing to avoid shock or damage.
• Use proper tools for the 8-32 stud terminals and ensure secure electrical and heatsink connections.
• Inspect mounting surfaces and replace any damaged hardware or thermal pads as needed for safe operation.

Fix refrigerator vibration or rattling noise with this compressor mounting clip. Secures the compressor to reduce movement. Quick 15-minute repair.

This center track screw cover caps the exposed screw on the center track assembly to protect the screw head and give the track a finished appearance. It helps reduce debris buildup and prevents accidental snags on the screw head. What it does:

• Covers and protects the center track screw head from dirt, moisture, and surface wear
• Helps maintain a smooth surface on the track to reduce snagging or catching
• Restores the OEM appearance where the original cap is missing or damaged
• Small replacement part used with center track assemblies and trim pieces

• One center track screw cover (cap)

• Designed for simple push- or snap-fit installation over the exposed screw head
• Remove power to the appliance before accessing internal trim or track areas, and follow manufacturer safety guidance
• If screw or track is damaged, inspect and replace the underlying hardware before installing the cap
• Handle small parts carefully to avoid loss during installation