Ml-Em45pit Parts

Size: 8-32 x 1/4 inch.

Size: 8-32 x .312 inch.

Size: 6 - 20 x 1 1/16 inch.

Dryer won't start when door closes? This door switch signals the control board to allow operation. Direct replacement takes 15-30 minutes.

This electrical connector links wiring within the appliance's harness, restoring a secure, reliable connection for proper operation. Use it to replace a damaged or corroded connector that's causing intermittent power or component failures.

• Creates a solid electrical connection between harness leads
• Helps resolve issues like intermittent operation, no power to a component, or visible heat damage at a connection point
• Maintains correct current flow and reduces risk of arcing at loose terminals
• Designed to fit the specified harness location per model

• Disconnect power and shut off utilities before servicing
• Match wire colors/positions and transfer one lead at a time to avoid miswiring
• Ensure terminals are fully seated and the connection is snug
• Inspect surrounding wiring for heat damage or corrosion and address as needed

This terminal block connects the appliance to household power, providing a secure point for the incoming power cord wires. Replacing a damaged terminal block restores a solid electrical connection and reduces fire risk. What it does:

• Secures and organizes incoming power cord wires to the appliance's internal wiring
• Provides stable electrical contact for consistent power delivery
• Prevents loose or arcing connections that can cause intermittent power or overheating
• Common symptoms: appliance won't power on, intermittent power loss, visible burning or melted plastic at the power entry point

• Disconnect power at the breaker and verify the appliance is de-energized before starting
• Confirm wire placement and tightness; replace any scorched or damaged wiring or connectors
• Use proper tools and follow the appliance wiring diagram; tighten terminal screws to manufacturer torque if specified

This seal creates a tight barrier between mating surfaces in your appliance, helping contain heat, air, or moisture as intended. Replacing a worn seal helps maintain performance and reduces the chance of leaks, drafts, or condensation at the joint.

• Provides a tight gasket between designated components
• Helps prevent leaks, drafts, or heat/steam escaping for proper operation and efficiency
• Restores fit when the original seal is torn, compressed, brittle, or missing
• Common symptoms include poor sealing, condensation or residue around the joint, or visible wear/damage to the old seal

• Disconnect power; shut off water or gas before servicing
• Note seal routing/orientation and remove the old seal; clean mating surfaces of debris/adhesive
• Install the new seal evenly without stretching or twisting unless OEM instructions specify
• Reassemble and check for proper closure and operation; inspect for leaks or gaps

Secures panels and components in place. Replace this fastener if stripped, corroded, or missing to restore proper alignment and eliminate rattling.

The Coin Drop Assembly is an OEM replacement part for Whirlpool washers. It allows users to insert coins and activate the machine on commercial or coin-operated washers.

A bad coin drop assembly can be caused by wear and tear over time or damage due to excessive use or mishandling. If you notice issues such as the coin mechanism not working, coins getting stuck, or the machine not starting when coins are inserted, it may be time to replace the coin drop assembly.

Symptoms of a faulty coin drop assembly include:

• Coins not being accepted or not registering
• Coins getting jammed or stuck in the mechanism
• Inability to start the washer with the coin insertion

Restore the function of your Whirlpool commercial washer by replacing the old or damaged coin drop assembly with this genuine OEM part.

This part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Secures hoses to fittings in washers and other appliances to prevent leaks. Replace when clamps lose grip or show corrosion. Confirm fit with your model.