Wd10404012 Parts

Connects your washer's supply hose to internal plumbing, preventing leaks at the inlet. Replace if you notice dripping or poor water flow during fills.

Secures rubber hoses to fittings with constant spring tension to prevent leaks. Replace when rusted or weakened to maintain a tight seal. Confirm fit.

This Leg Adjusting Wrench is a simple tool used to turn and secure appliance leveling legs so washers and dryers sit flat and operate quietly. It makes adjusting legs faster and helps reduce rocking and vibration. What it does:

• Fits over standard appliance leveling legs to raise or lower each corner
• Helps stabilize machines to prevent rocking and uneven operation
• Reduces vibration and noise caused by unlevel appliances
• Useful when installing, moving, or re-leveling washers and dryers

• Turn legs slowly and adjust one corner at a time until the appliance sits level.
• Unplug the appliance (and shut off gas supply for gas dryers) before performing major moves or checks.
• Use caution to avoid pinching fingers when lowering legs; keep hands clear of pinch points.
• Check for damaged feet or mounting hardware and replace as needed.

This power cord assembly supplies AC power to the appliance and restores safe operation after a damaged or faulty cord. It replaces the worn or frayed factory cord so the appliance can power on reliably. What it does

• Provides the main AC connection between the appliance and household power
• Replaces cords with visible damage, exposed wiring, burnt connectors, or intermittent power
• Helps stop arcing, sparking, or overheating caused by a failing cord
• Fits into the appliance's cord terminal block for a direct, plug-in power connection

• One power cord assembly

• Disconnect power at the breaker or unplug the appliance before starting any work
• Tighten all terminal screws securely and route the cord away from sharp edges and moving parts

Fix a washer that won't fill with water or fills too slowly with this inlet valve assembly. Controls water flow and pressure during wash cycles.

Replaces a cracked, warped, or missing lid on top-load washers. Restores safe closure and finished appearance. Installs on top of cabinet housing.

If your washer won't fill with water or leaks during fill cycles, a damaged inlet hose is often the cause. This hose restores proper water flow.

Fix an unresponsive or blank washer display with this display power control board assembly. Restores front panel controls and visible indicators.

Fix a washer display that won't light up or respond to button presses. This control board powers the front panel and restores console functions. DIY repair.

Washer won't turn on or power button doesn't respond? This push-button switch restores tactile on/off control without replacing the entire panel.

Connects your washer to the home water supply. Replace this inlet hose if cracked, leaking, or worn to restore reliable water flow during fill cycles.