Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
A single replacement screw used to secure appliance panels, trim, and internal brackets so components stay aligned and reduce rattling. Simple, direct-fit fastener for restoring proper mounting and stable operation. What it does:
Not hard when you have videos and a mechanical background....piece of cake.... Read more
This shipping bar was installed during appliance transport to secure moving parts and prevent damage. It should be removed before first use to allow proper operation of your washer's door mechanism. Remove this bar if your washer door won't open properly or if you hear rattling noises during operation.
Metal sheet-metal screw secures panels, brackets, and internal components. Replace when missing, stripped, or damaged to restore proper fit.
My washer and dryer was stacked and I needed the right parts to put the tops and "feet" back on them. Read more
Size: 8 - 18 ab.
Door hook for washer models. Secures the door latch mechanism during wash cycles. Replace if hook is broken, cracked, worn, or missing to restore door closure.
Stainless steel hex washer head screw for securing appliance panels, brackets, and trim. Replace missing, stripped, or corroded fasteners during repair.
Alignment pin keeps washer door hinge positioned so the door closes evenly. Replace if cracked, bent, or missing to restore proper door fit and seal.
Replaced washer tub straps and a broken strap retaining clip. Read more
Washer not starting or displaying error codes? This sensor monitors cycle functions and signals the control board. Typically a 20-30 minute repair.
Air conditioner not cooling properly or cycling on and off? A faulty sensor may be misreading temperature. This sensor helps restore accurate climate control.
Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.
Hex washer head screw for washer pedestals. Secures pedestal components and panels. Replace if screw is stripped, missing, or damaged during assembly.
I had to remove the front panel of the washing machine and top of the washing machine. i started by removing all the top screws as shown in one of videos. disconnected all the electrical wires (i have a commercial washer) and lifted the front panel over the back of the machine. i was then able to remove the top of the washing machine to give me access to the tub straps and the corresponding screws. i removed the broken straps and then was able to remove the tub cover by pushing down it down... Read more
Replaces worn or damaged washer sound dampening isolator. Reduces vibration and noise during wash cycles. Essential when original is cracked or missing.
Grounding stud for top-load washers. Connects electrical ground wire to washer frame. Replace if stripped, corroded, or missing for proper grounding.
Size: 1/4 - 20 b.
OK kids, pay attention! This was my second attempt @ this repair. My first repair started leaking right away and had to be re-done about 6 months later. HERE IS THE PROBLEM!. In the video, you'll notice that (while putting it back together) when you put the square hole washer and split-ring over the shaft, they look to land atop the rubber seal, buy when you do this in real life, there is a gap between the seal and the washer. (This gap was close to a 1/4 inch). I THINK that the first time I... Read more
Size: 8-18 b.
Purchased new RPS Hall Effect sensor, pulled rotor and stator and installed new RPS module. Works fine after new sensor! Repair took about 30 minutes. Perfect! Read more