Kurt I have a model LRG3091ST/02 range made by LG it is plugged into a GFCI outlet after trying to turn it on bake it tripped the GFCI. I pulled the back panel and checked for burnt/bad wiring all is ok. I unplugged one connection at a time and would set it to bake and it would trip the GFCI until I got to the temp sensor. once removed I could go to bake and it would attempt to start but would click out of bake and beep several times. I ohm tested the temp sensor and did not get any reading. thinking it was bad I ordered a sensor and replaced it. I'm back to the same thing. I am thinking the power supply board is bad? Thank You
Answer Hello Kurt, As per the installation guide for this model: A word about GFCI's- GFCI's are not required or recommended for gas range receptacles.Ground Fault Circuit interrupters (GFCI's) are devices that sense leakage of current in a circuit and automatically switch off power when a threshold leakage level is detected. These devices must be manually reset by the consumer. The National Electrical Code requires the use of GFCI's in kitchenreceptacles installed to serve countertop surfaces. Performance of the range will not be affected if operated on a GFCI-protected circuit but occasionalnuisance tripping can occur. Read More... Answered by AppliancePartsPros.com | Thursday, August 8, 2019