Dave for Model Number DLG0452W The dryer will not activate the gas valves to fire. The Ignitor glows after a minute and then shuts off, but no gas is released to ignite. I replaced the Gas Valve and still the same result. I have checked resistance and Continuity to all sensors and they read as working. Is it possible the flame sensor is malfunctioning? It appears to work as the Ignitor cycles on and off. There is continuity (closed) when I read the Sensor but I have noticed that when I power up the dryer that the upper part of the sensor reads 120 volts but the lower connector reads none even when it appears to have continuity? I was assuming that the flame sensor would pass through the power? I am at a loss and am also wondering if it could be the control board? Thank you for the help.
Answer Dave, With the igniter coming on but there not being any flame and new gas valve, the flame sensor would most likely be causing the unit to not light. Read More... Answered by AppliancePartsPros.com | Monday, October 6, 2014