Alan for Model Number DLGX4001B Dryer is 4-years old. Control board display reads "gAS" at the end of a drying cycle (air drying). All gas lines and valves are open (for the last 4 years). Ducts are clean, as is the dryer internal. I disassembled the dryer, checked all thermostats and flame detector for continuity and resistance: all good (continuity) and < 1 ohm); door switch checks out; igniter resistance was 430 ohms and looks in good shape; both valve coils read 1.92 k-ohms. I also took off the coils from the valves to inspect and all looked clean and valve shafts free to move. I did not mess with the regulator! I had this problem (gAS on the display) about 10 months ago, but for fun we tried a manual dry cycle (usually dry on Normal) and low and behold our problems disappeared - until this week. Could the igniter or valves still be bad? Or the control board? Thanks!
Answer Hello Alan, thank you for contacting AppliancePartsPros.comThe gAS error code means that the control board cannot detect proper gas flow, air flow, and/or ignition. With the venting and dryer being clean and clear, and the components testing within range it may be that the control board EBR31002602 itself is the issue. Read More... Answered by AppliancePartsPros.com | Monday, July 7, 2025