Customer Questions and Answers for Trim Panel (30 In. Stainless Steel Cladding) by Whirlpool

Kirk, Heres some help : " 1. Disconnect the electrical power to the double oven. 2. Open the lower oven door. 3. Remove the bottom screw from each of the two side trim pieces. 4. To remove the side trim, pull the bottom out approximately 2?, and slide the top down to free it from the control panel.5. Remove the screws from the oven control panel.6. To remove the oven control panel, pull it out at the bottom, and lift and unhook it from the oven cabinet support at the top. 7. Disconnect the wire connectors from the control board and set the panel face down. To remove the oven control/display boards: a) Remove the mounting screws. b) Lift the ends of the locking arm and disconnect the ribbon cable from its connector. NOTE: The control and display boards are designed to be replaced as an assembly. To remove the touch panel assembly: a) Push the window and flat ribbon cable area out of the control panel so you can grasp the edge of the touch panel on the other side. b) Lift and peel the touch panel assembly off the front of the control panel. on a padded surface to protect the finish." Good Luck and Thanks