Trent for Model Number 110.84832201 I asked a previous question about my dryer not starting after replacing belt, pulley, and rollers; you mentioned it could be the pulley switch. I checked with Ohm meter and is OK. Could the new belt be a bit too long, so that it is not raising the pulley off the switch?
Answer Hello Trent. The new belt should be good and tight, if it is on the pulleys correct. If it feels loose and is not closing the contact of the switch, the dryer will not run. Check and make sure you have it on the pulleys correct. Hope this helps. Read More... Answered by AppliancePartsPros.com | Tuesday, April 5, 2011