James for Model Number Kenmore 110.82824101 The dryer stopped working and it smelled like something burned. Pressing a cycle and start the drum rotates once and stops, you can hear the motor relay clicking. I replaced the motor relay (T9AS1012-12) and the dryer started and ran a empty for a half hour w/o heat. Tested with small load of cloths and it stopped again same problem. Do have the burnt smell around the control board. Door switch, thermal fuse, and thermal cutoff and heater all check out with ohm meter OK. Drive motor reads 1.8 ohms on both main winding and start winding (manual says should be 2.4 to 3.6 ohms). It is 2 ohms at the connector to the motor control board. I can rotate the motor using the blower wheel. It does seem like it is harder to rotate the drum manually. Recommendations?
Answer Hello James. Based on the information you provided, it sounds like the motor is bad on the unit and needs to be replaced. It sounds like the motor is getting hot and shutting down. Read More... Answered by AppliancePartsPros.com | Thursday, October 18, 2012