Tracy B. In the video they say the black sensor should be on the top and the yellow on the bottom. I just took mine apart and it is the opposite. Should I flip them? My original issue was during "normal" cycle I get a check vent signal and it's clear so I use the timed cycle and have to run it for two hours to dry a normal load. I took out the sensors and cleaned them.
Answer Hello Tracy, The connections do not make any difference in this case as it is a non polarized circuit. This sounds like the ducting in the home is going to be the cause of the issue. There needs to be a full 4 inch diameter to outside "atmosphere". The duct also needs to be short and straight as possible. Read More... Answered by AppliancePartsPros.com | Thursday, October 1, 2015