Robert for Model Number MED2000AW0 Followed your video that told me to remove two screws from the front and three screws from the rear. Problem is my dryer does not have a center screw in rear - just a tab that is not an obstruction. However, I cannot remove the piece to access the thermal sensor for replacement. Something else is holding it in place. Any ideas?
Answer Robert, unfortunately, the model provided is not showing as a valid model. If the model could be verified from the model tag and provided in a new post, this may allow the most accurate information to be presented. Generally speaking, there would have to be a screw holding onto the housing. If it can not be found, the dryer front panel can be removed to access the bulkhead to change out the sensor bars. Read More... Answered by AppliancePartsPros.com | Thursday, December 28, 2023