Customer Questions and Answers for Reciever, Hinge by Whirlpool

Hello Tymcrobert. Install a pin in the hole of each oven door
hinge hanger. Close the oven door as far as the two pins
will allow. Grasp the sides of the door and lift the door
until it stops, then pull the hinge hangers
out of the slots. To reinstall the oven door: 1. Grasp the sides of the door and tilt it back
at a slight angle, then insert the hinge
hangers into the hinge slots as far as they
will go.
2. Rotate the top of the door towards the
oven so the hinge hangers fit onto the
support pins.
3. Close the oven door as far as the pins will
allow, and make sure that the hinge hangers
are fully seated on the support pins. If
they are not seated properly, the door will
not close tightly and may be off-center. To
seat the hinge hangers, open the door
slightly, and push in on the bottom until the
hangers are fully seated.
4. Open the oven door to its fully open position
and remove the two hinge hanger
pins.
5. Close the oven door completely and check
it for proper operation and alignment.