Jerry H for Model Number 110.92596100 Kenmore Washer. Unit did not pump out. Installed new drain pump and pumped water out with new pump. Reassembled washer. Went to use washer & washer did not stop filling. Big mess. Installed new water level switch (ap30119660). Reassemble water keeps coming in on wash, rinse etc with washer plugged into outlet. Unplug from outlet, water stops. Everything looks hooked up correct. Followed old wiring colors on new switch. Vacuum hose air tight when holding one end and sucking in. When hose unhooked from tub water spews out as tub full. Hose s/b OK. I do not know how to check wiring if that is recommended, but could follow suggested procedure checks. Tub is full of water but I think it should empty anyway. I think if I let water run too much it will overflow and it should sense sufficient water in tub to quit filling. I'm on city water & pressure adequate. Suggestions? I'll try anything.
Answer Hello Jerry. Drain out all the water then blow through the pressure switch hose. Clear the air dome on the tub assembly. Now, install the hose onto the pressure switch and take it for a test spin. Read More... Answered by AppliancePartsPros.com | Friday, August 9, 2013