Customer Questions and Answers for Water Level Pressure Switch by Whirlpool

Nuckles, here's some basic help : "Servicing Components in the Console 1. Remove the two Phillips-head screws securing the front corners of the console to the washer top. 2. Tip the console back on the hinges that secure the top of the console to the washer back. Removing the Timer There are two types of timers. One can be identified by a plastic body. The other has a metal body. Plastic Body NOTE: DO NOT ATTEMPT TO REMOVE THE TIMER KNOB BY PULLING FROM THE FRONT. Doing so will damage the split shaft and require replacing the entire timer assembly. Actually, once you have the console loose, you need to remove the knob, and disconnect the air dome hose from the switch.then remove the cabinet to access the air dome hose where it attaches to the outer tub assembly, on the right rear portion of the tub. Components inside the washer cabinet can be accessed by completely removing the outer cabinet as one unit. 1. Remove the console mounting screws and tilt the console into the service position. 2. Unplug the lid switch harness connector from the receptacle in the washer top. 3. Remove the cabinet mounting clips by placing the flat blade of a screwdriver in the clip. 4. Remove the cabinet by tilting it forward and pulling it away from the washer. 5. The rear panel can be tilted back for additional access to components at rear of machine by twisting the rear panel support 90°. and then tilting the rear panel back." Good Luck and Thanks