Brime i have up rigth freezer kenmore madel#106-8253580, i installed defrost timer part#482493,with terminal#1 black two wires,terminal#2 pink 1 wire,terminal#3 red 1 wire,terminal#4 orange 2 wires,i try the black terminal from the timer in terminal 1 and 2 but i have no defrost,what do you think is the problem,the unit has a new defrost limit, and also i check the defrost heater ok,thanks.
Answer Brime, based on your wiring information in your post, you have "version 2" and you followed Procedure 2 on page three of the instuction manual, is that correct ? You do understand that the defrost cycle will not activate until the compressor has a total of 8 hours of run time( this could take a couple of days to accumulate the time). Here's a quick test and check. With the freezer plugged in and cooling, slowly advance the defrost timer with a screwdriver, until the timer "clicks" and the compressor turns off, this will be the defrost cycle, in a few minutes you should hear the water sizzle when it drips off the evaporator and hits the heater. In 25 to 30 minutes you should hear another click, and the compressor should start to run in a few minutes if not right away. Thanks and Good Luck Read More... Answered by AppliancePartsPros.com | Wednesday, December 7, 2011