How to Troubleshoot & Replace Ge AP3670139 / WR02X10568 Hinge Cam Riser

Simply removed top door hinge held in place with a screw and two small 5/16 inch bolts . Lifted the door off bottom hing . Replaced old cam riser with new cam riser . Replaced refridgerator door and top hinge . Adjusted door height with 5/16 wrench matching it with deepfreeze door . Patted myself on back for such a good repair job . Lol . I'm very pleased with part delivery time , less than 24 hours . 

Replaced the two parts ordered. 

1) By using google to find videos on why the door wouldn't close, I found out I needed new cams, those same videos also showed how to remove and replace the door. 2) Then by googling the fridge model number and the word 'cam', I was able to find the parts. 3) Taking the door off was simple, I needed a phillips head screwdriver to remove the hinge cover, however the screws in the hinge plate were so tight, I needed a side handle socket wrench to loosen them. 4) The door itself is not hard to handle than say one of the old Dyson Vacs from the 90s. 5) Replacing the cams was simple, just remember one of those cams is on the ubderside of the door so you have to turn the door upside down once you get it off. 6) Along with the replacing the cams I also added a trust washer under the cam that sits on the hinge attached to the body of the fridge. (not on door bottom). 7) Putting the door back on was a little tricky, but nothing big. --------------> LESSON LEARNED <--------------- 8) The door STILL would not close properly after completing all the above steps,ONLY after RELOADING all the grocery items back into the door compartments, did the door start shutting on its own again. ((I am a 65 year old female with no specific skills in fixing appliances.)) 

I ordered cam risers (door riser and hinge riser) removed and replaced in 30 minutes. Problem solved. 

As others posted, simply remove the top hinge cover and two bolts after unloading the door of items, remove the door, replace the cam, and put it all back. Super easy! 

Replaced door hinge cam riser. Took longer to go online and look up and order part than it did to install. 

Remove one phillips screw on of the door cover, and then removed two 5/16 inch nuts. I then lifted up the door completely free from bottom hinge, and and then replaced the hinge cam riser (by simply removing the broken piece and and inserting it back in - took 2 seconds). Finally I placed the door back on to the bottom hinge, and then reinstalled the 3 screw/nuts on the top of the door. Whole thing took about 3 minutes. 

Ordered new piece. Took door off and replaced it with new washer. Re-attached door. Tested.