Viresh R River Forest , IL November 02, 2018 Appliance: Model VWH3048-SS Viking range hood model # VWH3048SS lights and dimmer did not work A search of the web indicated that it was a faulty dimmer knob. The original part number was PE050033. It was replaced by PE050141. This item was available through some sites, but costs ~$120. I found that on the site for ApplicancePartsPros.com it said that PE050141 been replaced by 062057-601, which is priced around $75. I tried ordering 062057-601 from All Viking Parts, but they send me a note that it was not suitable for my hood. I double checked with ApplicancePartsPros and they said it would work, so I ordered it and installed it. It works like a charm. The installation requires some effort. The first thing you do is turn of the circuit that powers the hood. I forgot to do this and got a shock when I went on to one of the later steps!! Make sure there is no power coming to the hood. Then, remove the two rotating dimmer knobs by pulling them out. Then, remove the two steel filters inside the hood and remove the heatlamp assembly. Then, remove the 3-4 screws that holds up the inside of the metal flap covering the electronics of the hood. Sit back against the wall and pull down the steel flap until you can reach in and disconnect the wire to the power. Label this wire using a masking tape. Put labels on each of the wires that are connected to the different knobs and switches (lights on/off, dimmer, vent on/off, vent dimmer, heat-lamp on/off). You might also want to take a photo. Then disconnect all the wires to the dimmers and switches. You have not now remove the three switches. These are held in by the squeezable end of the switches. You have to use a channel-lock or fine some other way to squeeze the edge of the switch and pull it out. When you remove all three, the metal place in the front will be freed. You can then remove the nut that holds the light dimmer, then pull the dimmer out. Replace with a new dimmer (as noted above, item 062057-601 works fine) and retrace all your steps. Good luck. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Jim G Alton , UT August 12, 2017 Dimmer switch on hood lights went out Ordered the perfect part from you and replaced the burned out switch. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers