Jonathan D Erie , PA January 26, 2015 Appliance: Jenn-Air Self Cleaning Slide-In Electric Range SCE4340B-C Left rear burner wouldn't heat on my glasstop electric range Unplugged range. Removed 4 phillips screws holding front control panel on.Lifted up panel and layed forward.Pulled the 2 wires going to burner off and tested for continuity with my test meter. Found burner to be open(no continuity) so I ordered new burner that night. Could not believe how fast it came! Not the next day but the day after it arrived! I slid the range out and removed the two 1/4" screws from each side and 4 from the rear edge. Carefully lifted up glass top, removed ground wire so I could turn top over and lay flat upsidedown. Removed 2 screws holding bracket to frame and unclipped burner from bracket. Took wires off old burner and removed spring clips from old burner noting which holes they were in. Screwed spring clips on new burner in corresponding holes as the old one and attached wires. Put clips back into bracked slots and reattached bracket to frame. Flipped over and reattached ground wire and set top back in place making sure it aligned with holes along sides and rear edges. Screwed in place and atached front control panel with phillips screws. Slid range back in place and plugged in. Tested out;voila! It is working great again! Thanks for getting me the part so quickly and at the best price too! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers