This was tough to diagnose Bosch Dishwasher issue. SPE53U56UC ~2yrs old. Sometimes the detergent tablet would not dissolve and would sit in the handle on the top rack, but not every cycle. Sometimes the dishes had food "baked on" as if there were not enough water.. but not always. Water was always hot. Water always drained properly. No leaks. Dirty dishes often not getting clean, but were wet at the end of the cycle. Doing some digging online I self diagnosed/guessed it could be the "Alter. water distributor". Couldn’t find instructions on this part anywhere, but the symptoms made sense.The Heat pump sends water to the distributor. If the distributor is not working properly then water won’t go to the pipes and spray arms. The diverter has a 5v motor & plastic gears so anything could go wrong. For <$50 I bought a new part (00753350) and ran with it.
The Water distributor is literally in the middle of the dishwasher and a pain to get to.. This project took me 6hrs.
I recommend finding online videos covering how to replace the heat pump & drain impeller. Follow those to show how to remove dishwasher bottom and those parts.
Remove the dishwasher bottom tray. Do this repair with the dishwasher lying on its backside.
Now you can access the Water Distributor attached to the bottom of the Sump.
Take pictures at this point... you may need to ref. them later.
There is one single clip (lower left side) you nudge out of the way so you can rotate the distributor counterclockwise to remove.
Compared Old and New Distributors... The white disk with the various shaped holes was rotated in a different position than the new part . The disk does not appear to be movable (can't just spin it). If the old unit disk was "misaligned" then the holes won’t line up at the correct pipe opening at the correct cycle time. Maybe this was the problem.
I Ohmed out the pins on the 5v stepper motor of the old and new parts. Everything matched. The motor was probably still good on the old one, but I had a new one and replaced it anyway.
I put the new O-Ring on the outer ring of the Sump Pump first, then installed the Water Distributor. It takes some force to get it on (pressure against the O-ring). Rotate the Waterdistributor clockwise and make sure it's fully snapped in.
Reverse step everything and reassemble.
Ran the dishwasher for one cycle and the issue was clearly resolved... Could hear water sloshing around inside like it was new again. Hopefully no leaks from my work will show up.