Do-It-Yourself Story

Removed and replaced control board. Had to unfasten oven from cabinet (8 screws) in order to pull unit 3 inches out of cabinet in order to remove four hex head sheet metal screws holding the display and control board housing. Disconnected 11 connectors after labeling them. Removed housing with control board. Disconnected two flat cables coming from housing by loosening clamp connector on old board. Removed board by removing 4 hex head screws. Reassembled by reversing these steps. Checked operation before reattaching unit to cabinet. Clamp connectors were a bit tricky as they are flat cables that are held in place by clamp that is part of the connectors. It looks like it should disconnect but the plastic clamp piece only moves up about 1/8th inch and stays with connector. The other connectors are well lacked on the board. I marked connector body with connector number so I could reinsert properly in new board. Would have been nice to have instructions.