Robert A North Reading , MA December 10, 2019 Appliance: General Electric Electric Range RB787WC2WW Ge Range Rb787wc2ww: Control board failed. How to replace Control - To8 (Thermo). I replaced the control board with the one I bought from Appliance Parts Pros. The replacement was fairly straightforward, but would have been even easier if the control panel overlay label was still available. If I could have bought the label, I would have applied the new label to the new control board assembly before installing the assembly, which would have taken less than five (5) minutes. Because I couldn't get the label, however, I had to remove the old circuit board from the plastic carrier, remove the new circuit board from its carrier, then carefully insert the new circuit board into the old carrier that had the old label on it. This had to be done very carefully, to prevent damaging the old plastic frame or the new circuit board. If I damaged the old frame, then I wouldn't have a label for any of the front panel switches, and would have wasted the cost of the replacement control board and requiring us to buy a new stove. Fortunately, the transplant was successful, but the need to perform the transplant took a five minute job and turned it into a 45 (45) minute job. The transplant took a five (5) star job and turned it into a four (4) Star rating and took a difficulty rating from a rating of one (1, i.e., ridiculously easy) to a three (3, moderately difficult), on a scale of 1 to 5. Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes