I removed the spring-loaded wire holding the diaphragm in place. I removed the three screws holding the switch in place from the front chassis. I then pulled back the diaphragm back to expose the switch housing. I removed the old switch from the plastic housing and then disconnected the existing wired three plugs. Inserted the new switch into the housing, reattached the wires, and then fit the housing/switch back into position. I then secured the switch with the removed screws. I then carefully refit the diaphragm and put the spring-loaded wire back into place. Works like a charm. We need to be more careful about accidentally slamming the washer door. The plastic parts just are not up to abuse.