1. Unplug unit,removed rear clamps W/ 5/16" nut driver.
In front push in tabs about 2-1/2" in from corner with putty knife or scraper,lift off lid lean it against wall.
2. Remove the (2)5/16" screws @ top corners of front panel and pull up to remove.
3. Remove the 4 screws holding the plastic seal on front of drum and set aside.
4. From the bottom pull belt tension pully down and pull belt off motor shaft,now pull drum straight up and set aside.
5. Unplug motors wire harness pinching tabs in and pull up. Pry retaining clip in front and back of motor mount out.
6. Unscrew fan in front of unit counter clockwise as indicated on the fan.(may have to use vise grips to clamp motor shaft to remove).
7. Pull out motor
8. Install new motor, retaining clips and fan.
9. Plug in motor wiring harness
10. Put back together as you took it apart. I also replaced belt and drum rollers while I had it open.Good luck!