Charles S Missoula , MT November 06, 2018 Appliance: Whirlpool LSR8244EQ0 Whirlpool Washer Lsr8244eq0: Extra rinse cycle switch not working. How to replace Washer Cycle Selector Switch. Piece of cake! First I unplugged the Whirlpool washer. I first removed the knob from the old switch and took note which direction the switch needed to be place to show on and off. The washer has two screws (on front at right and left side) that I removed from the control panel. The panel then rotates up to expose all of the backside of the timer and switches. Initially, I thought I had to take the entire panel apart but after looking it over realized that the square extrusion on the front of the new switch and outrigger tab would be used to secure the switch. So, unplugged the old switch, gently pulled the outrigger tab on the old switch out of its square hole and turned the old switch approximately 30 degrees and it came right out. The new switch went back in perfectly and now the extra rinse cycle works great. Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes