The repair was straightforward. I found a video on YouTube that took me through the steps. Take off the lid of the washer by unscrewing the 3 screws on the back of the machine. Then unscrew the 2 torx screws in the door area to release the Door latch part. After that it was just figuring out how to get my arm in enough to unplug the 2 wiring harnesses—it's a tight space. That took the longest because I really needed 2 hands to release them, and only 1 arm fit in at once. After much sweat and contortion I managed to unplug them. Reistalling was easy once I realized I could snip the zip ties holding the wires in place to lift them out higher. I should have done that sooner. After plugging back in and rescrewing the part to the front door area, I replaced the zip ties to keep the wires off to the side. Then placed the lid back on. Total time to replace the part was about 30 min. Machine is working again.