The evaporator fan was failing (noisy, and sometimes not starting when it should).
I removed the back panel of the freezer compartment by unscrewing all of the hex screws. Had to use some pliers to extract the unused ice-maker connector from the retaining slot.
I used pliers to gently remove two cable holders on the front of the fan box. Then removed the two bolts retaining the fan assembly. Two ground connections, 1 power, 1 neutral removed to get it out of there.
The replacement fan has power and neutral connections in different locations, so the existing power connections were too short to connect. There were a few extensions in the box with the fan, so I trimmed the protective sleeve on one of them so it was the proper length, and I extended the power cable to reach the other side as I connected the others to the fan assembly.
I reinserted the cable holders on the front bottom edge of the motor box and then mounted the assembly with the two hex screws.
I wasn't sure if the power/neutral connections were correct, so I plugged things in to make sure the fan was spinning in the correct direction. (not sure if it matters, actually). But the fan was blowing upward as required.
I reinserted the ice-maker plug into the retainer hole and remounted the back panel.