Cold water issue. Blew through pressure hose (which is attached to main control board). Hose was free from clogs. Put washer in test mode number 6 and hot water came on and also had 120volts ac at hot water valve in washer. Put in cold water test mode number 7 and washer clicked and cold water did not come on also no voltage at cold water valve in washer. Checked resistance across valves. They tested around 1000ohms, which is within range. If they read OL then would be bad.
So after these test I concluded that my valves were good but I was not getting voltage from main control board to cold water valve.
Ordered main control board from Appliance Parts Pro and it came in the next day. Installed it and ran cold water test. Test was good, had cold water. I put a load of clothes in and ran a normal cycle, which takes about 55 minutes all good. Appears washer is fixed.