I removed the rear cover and verified that I had 230 volts going to the element with the oven set at 350 bake. The element was not getting hot. I turned off the power to the oven and removed the wires to the lower element and using an ohm meter verified the element was open (infinite resistance) I looked up the model and part number at Appliance pros and ordered it. 3 days later the part arrived and after turning off the power to the oven. I removed the back cover and the leads to the lower element. There were two small screws on the inside of the oven at the back of the element. After removing these the old element slid right out. I installed the new element and put the screws back in. Attached the wiring leads, put the back cover back on. And turned the power on to test it. It works now just like it is supposed to. Thank you.