I removed the face plate to the water and ice dispenser by removing the water tray and the three screws behind that. I removed the face plate by lifting up on it once the screws were removed. I disconnected the wiring harness and removed the circuits board by unscrewing the 3 screws holding it to the door. I detached the wiring harness on the left but was unable to pull the hose out from where it connects from the wiring dispenser. I was able to remove the ice door bracket by pushing a pull pin out and removing the spring. I recommend taking pictures as you move along to remember the orientation of everything. I replaced the bracket and returned the bracket with the spring and push pin in place.