Bryan A Montgomery Village , MD June 13, 2020 Appliance: Model GE PROFILE JE1590SH Intermitent operation Telling this to help others diagnose their microwave. We would use the dual cook mode (convect & microwave), set the convect temp. & time, then press start for it to warm up. The when it reached temperature and was ready to cook, we would open the door put in the good and press start. The only thing that happened is the clock would start to count down. Or, we would just microwave something, and then try to microwave something else right after that. The first cycle worked, but the second just counted down the timer. Wait 30-45 minutes and it might function properly again but like I just described. Everything I could read says it's almost never the controller board. So I checked everything I could: diode, door latch relays, thermostat, etc. Finally replaced the controller board. It's smaller than the original, but fits in place just fine. All the connectors are keyed and unique, so they are easily reconnected. The new controller came with a ground wire - easy enough to see where to connect it. Be gentle with the electronics pieces slide and lock into place and it's not always obvious. I'm happy I did this because the microwave is a counter top model built in to a cabinet with cover face kit. This story was written 2 months after the repair to make sure that was the problem. We've used it probably 100 times since - all good. Do-It-Yourself Rating: Repair Time Estimate: 2+ hours