New drum rollers and idler pulley. I knew the drum rollers were bad but were not sure about belt and idler so I disassembled it before I ordered parts. The idler was bad and I could barely turn it. The belt was ok but I decided to replace it anyway
The rollers have fiber washers on them which are not supplied with the new rollers. These may be worn so I would order them next time. I went to ace and had to use metal washer which I hope holds up
If you do not have a snap ring pliers you should buy one because it makes it very easy to do this job. 30 minutes to take apart and 30 min to clean and assemble. I also used a dry lube on all the shafts which were not in the video. This dryer is identical build to some Maytags if you are looking for a YouTube video. You start by taking off the lower kick plate, then the front panel and door together, then the top, then the front panel supporting the drum. It only takes 10 min. The clean and inspect the rollers. Replace the rollers and washers and put it back together.