Do-It-Yourself Story

I ordered the Oven Bake Igniter and replaced it. I had replaced an oven igniter before and I was confident that I could replace this one. However, the job took me all day and I practically took the whole oven apart! Getting to the igniter from the front was easy. Finding the igniter electrical plug was difficult I was looking for an access door to the igniter electrical plug connection and didn't realize that there wasn't one until I had practically taken the whole rear of the oven apart. I found out, after careful examination, the the plug was accessible through a small 2 inch hole in the rear of the oven where the power wire entered the oven! I used a hooked coat hanger wire to pull the plug out, undone the plug and pulled the igniter out from the front. I should have tied a string to the plug to make it easier to reinstall the igniter when I pulled it out from the front. Tie the new plug to the string and pull it back through the hole from the rear. I lost a lot of time needlessly by taking apart the rear of the oven looking for an access door. The job should have taken me no more than half hour if I had figured out this from the beginning. I made an easy job difficult! If you don't do my mistake, this is an easy job to do.