I ordered the part I was sure I needed through the Appliance Pro website. I was surprised the part arrived in just two days. FIRST UNPLUG THE OVEN.. I removed the baking racks then two screws holding the plate over the element. I then removed three screws holding the old element in place, then gently wiggle/pull the element free from the electrical connections in the back of the oven. (Note: You cannot see the connections at this point. You'll need to remove the terminal block cover on the back of the oven.) To do this, remove two screws from the cover then gently press the sides together and lift the cover from it's slots. You can now see the two electrical connections for the element. Return to the front of the oven and gently wiggle and push the new element into place through the back of the oven (Do not install any screws yet) Go to the back of the oven, connect the two wires to the two prongs of the element. Reinstall the cover then go back to the front of the oven. Now wiggle the element till it rests in place. Install two screws holding the element in place, re-attach the element cover with the two screws you took out. Plug in the oven and test the temperature using a oven temperature thermometer. Note that the new element was just a little different than the new one in that the old one had small supports on it. You don't need to transfer them to the new element. All this took about thirty minutes ( very easy to do,) and then my wife baked a cake. I was so happy. I'm 63 years old and was scared I'd mess it up. This is the second time time I've used Appliance Pro and I highly recommend them..