Had to pop ice dispenser cover off the front. Insert screw driver into slots from below and release two tabs and the covers supposed to come right off. Nope. It comes loose but won't pop out. Various sources say force it off. Hard to pry against stainless steel without scratching it and afraid to break a much more expensive part. So as an old experienced husband I wait for wife to get increasingly mad until she finally says "Go ahead and pry it off, if it breaks we'll just replace the whole part." So relieved of the burden of being the idiot that made the decision to break the part, I wrap a larger screw driver in electrical tape to protect the stainless and pry the cover off carefully. It pops off with a loud snap but nothing broke. Two more screws and disconnect the wires and it's out. Replacing part in the actual dispenser channel was a little tricky. You had to hold your mouth right while you lined everything up to get it to snap in. Went back together in 5 minutes after that. I should note that like an idiot, I never pulled out the refrigerator and unplugged it. I don't recommend this. But being an old married guy I don't fear death. Probably took about an hour total over three days. If I had to do it again it would take about 15 minutes.