Considerable trouble without adequate diagrams/schematics for proper inputs/outputs. Use of YouTube videos, including yours, and previous electronics experience. Identified power at L1 and L2 at machine terminals. Power at motor relay (L1; black) but not at Red (L2) wire on main circuit board. Based on common problems, I disassembled machine to access door switch, moisture harness and sensors, thermal fuses, thermostats, heating element, motor, and blower assembly. All tested good except for door switch which was replaced. This did not fix problem. Continued research yielded some diagrams/schematics but were inadequate. Finally, in discussion with "Mike" (no last name) he located tech sheets for my model and I was able to properly troubleshoot. If I had these to begin with I could have identified all other component input/outputs at the main control board (thermal fuses, etc) and would have located the signal going to the display panel when connector to panel was removed. Main board good; Display panel bad. Ordered part is very expensive (almost half of original cost of dryer, but your cost was at least a $100.00 savings over other new boards), and it was promptly shipped by you and received in 3 days. Please note that all staff were professional, friendly and helpful.