During the spin cycle my washing machine was making a horrible roaring noise. The internal tub had become separated from its hub and the “Spider arms” had broken due to corrosion. It’s only a 2019 model. After removing the agitator, I struggled to remove the hub nut. You can purchase the hub nut tool but I just cut the handle shorter on a pipe wrench and used that instead. It is a very tight space due to the 24in design of this model. The nut on my unit had become seized which is very common on these models. Remember that the nut is reverse threaded so clockwise to loosen and you can see it faintly written on the hub nut. After a few days of soaking in PB blaster, I had to change course. I ended up using 5/16 drill bit to drill into the nut on each side of the shaft to create weak points. I then used a cold chisel and hammer to effectively split the nut by chiseling down parallel to the shaft and making sure not to hit the threads. If you mess up the threads on the shaft the problem gets more expensive. After 3-5 minutes of the cold chisel the nut finally split in half. Removing the inner and outer tub was simple after the nut was removed. I broke the outer tub in the process of hammering so went ahead and replaced both tubs. It is important to know you cannot replace just the tub seal on this model. You have to buy the whole transmission assembly to replace the tub seal. Mine was still in good shape so I just heavily lubricated the creases with silicone grease. Parts from Appliance Parts Pros came quickly!