Robert B West Chicago , IL November 22, 2020 Appliance: Model C301BS/02 Thermador built in oven f34 error code The relay board (427198) was purchased for installation in a Thermador built-in single oven model C301BS/02. The oven was installed in December 2005. In recent months the oven would start-up and then stop with the display of error code F34. It would take 2 to 5 restarts until the oven would finally start. After replacing the cooling fan the error persisted. The Appliance Parts Pros Question and Answer section described a similar problem that was resolved with a new relay board. To install the relay board the oven must be removed from the cabinet. Be sure to turn off the circuit breaker before starting. Remove the oven door and racks. Slide the oven onto a dolly and platform in front of the oven. Once it is removed the top sheet metal panel (9 screws) is removed to access the relay board. Remove the brace over the board (4 sheet metal screws and 2 Torx screws). The relay board is held in place with one sheet metal screw. After removing slide the board right when facing the oven front. There are 8 plug-in connections on the old board that need to be re-connected to the new board. Be sure to take picture before removing the connectors just to have a reference. Some of the connectors are color coded to make re-installation easy. That’s it. Problem resolved. Took less than one hour from start to finish. Thanks to Appliance Parts Pros for their quick delivery and parts support of the Thermador oven. Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes