Turned off the breaker in the fuse box for the range.
With Phillips-head screwdriver, removed two screws. Set screws aside.
Pulled out the old element from the back wall of the oven until wire connections are out.
Disconnected the wire connector from each side of the element by physically pulling it off.
Removed old element.
With the new element, put it into the over in the same position as the old element (screw holes are on top).
Attach wire connectors to each end of the new element.
Push wires and element ends into the holes in the back wall of the oven.
Insert screws through tabs on the element and into the oven.
Turn breaker switch back on.
Turn oven on to test to check that the elements get hot.
Turn oven off.