I replaced the drain pump. The drive belt was old, so I replaced it too. The whole job took about 30 minutes. I pulled the washer away from the wall about a foot. Used a plastic putty knife to release the latches locking the cabinet top and leaned the top back. Removed two screws to remove the cabinet front. Used a brick under the front of the cabinet to raise it high enough to reach the belt underneath the cabinet. Removed two hose clamps and three screws to get the belt off and the pump out. I should have clamped the top hose before removing it because there was water in it and it poured out into the cabinet and onto the floor.