Dave V Streator , IL April 16, 2016 Appliance: Frigidaire Washer ATF6000ES1 A comed power surge in the neighborhood toasted several appliances The control board replacement was fairly easy. I took some pics during the disassembly process to ensure that the wiring and button interfaces were restored to the proper positions. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Gregory A Deep River , CT March 20, 2018 Appliance: Frigidaire Washer ATF6000ES1 Totally "dead" no display on Frigidaire washer Replaced the main controller module, after viewing the video. The replacement unit arrived in less than 24 hours, even though I expected 2 day delivery. WOW !! I had the new controller in and running in roughly 30 minutes. This washer is a front loader, of medium size 3.5 cu ft capacity and our upstairs washer/drier closet could not accommodate a unit more that 28 inches front to back. This saved me all kinds of problems replacing a 10 year old lightly used washer. Thanks !! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Samuel C Kathleen , GA May 02, 2015 Appliance: Model LFT6000ES0 Washing machine start and stop beep crazy After reading the Technical Manual I determine the Control board was defective. I followed the instruction in the manual to remove the old part. installed the new part and started washing again. It was not hard to replace, just ensue that up remove the button-pins, the control knob with the stick attached and Led Display from the old part and install them in the new part before you start installing the new part. The cost on the board is less then 1/4 the cost of the machine; our set is 8 years old...Job Well Done! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
James D Daytona Beach , FL October 31, 2014 No spin cycle washer shuts off at that point Fixed by replacing control panel. Diagnostic indicated error code E43. Also measured wax motor on door lock assembly. It did not read as expected (1500 ohms), it only about 1250 ohms, but was not the problem. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Alan S Hohenwald , TN June 01, 2016 No display on panel Replaced control and interface boards Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers