Frigidaire 316577040 Control Board OEM Part

Arrived home to smell burnt electrical wiring and upon investigating the source I found the LED on the over/range not lit up. The smell came from the EOC location on the front of the appliance. De-energized the appliance and removed the failed EOC (take pictures for reference to electrical connections) to identify the part number (AP5184574). Ordered via Appliance Pros. Part arrived a couple of weeks later. New EOC does not come with new electrical stand alone wiring so had to swap out the electrical connections from the old EOC to the new EOC. Also found a couple of seals that prevents liquids from dropping into the electronics were dissolved from oils or not in place as they were designed. Suspect this might have been a factory assembly issue that was overlooked regarding seals that were drooping and not in place. Did not see signs that liquids or oils were the cause of the failure. Time just wasn't on the EOC's side. During the EOC installing on the touch board I opted not to put the old swollen gasket on the board. I used sealant (silicone for automotive applications). After installing the EOC onto the touch pad center and connecting the stand alone wiring, I reinstalled the touch pad control onto the appliance and plugged it in. We heard the beep, saw the LED light up and tested controlling the oven. Everything worked perfectly. I did apply some sealant to the critical areas to prevent liquids from leaking down under the touch control board. One note about the fasteners, they look like Phillips head screws but they are not. They are square head deck screws. Total time to take EOC out was 20 conservative minutes for sake of capturing images and understanding what was going on. Time to reassemble took 15 to 20 minutes now that I knew where everything went. Flat head screw driver was used to lift electrical plug locks for disconnecting. Nut driver used on internal touch board fasteners. I think it was 8 mm. Square head screw driver was for the external fasteners. Total time I would say was 45 minutes from disassembly to reassembly.