Linda B Shamrock , TX June 26, 2015 Dishwasher door would not shut to run the cycle With your part thanks Read More... 19 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Tom W Arnold , PA December 06, 2016 My frigidaire dishwasher would start count down the time but never complete the wash cycle Bought a new door latch assembly, installed it in about 15 minutes and my dishwasher is up and running again. Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Glenda A Ft. Smith , AR April 05, 2015 Dishwasher door would not close The part i got from appliancepartspro did the trick and now my dishwasher is working as good as new again for about $20! I looked at a lot of other sites for this part and only found it here! Definately will be using this site again Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Leland H Marysville , WA May 10, 2023 Appliance: Frigidaire Dishwasher, Built-In FFBD2412SS0A The dw periodically stopped mid cycle before detergent door opened two months later it quick working completely My Frigidaire DW periodically stopped mid-cycle before the detergent door opened. I could hold the cancel button for 3 seconds, the water in the tub would drain and then I could start a new cycle. This would happen every few days. After about two months, it quickly worked completely. There were lights on the controls and I could hear switch click sounds when I would press the Start button, but the DW would not run. I talked to APP and others about the issue. The general opinion was the main board needed to be replaced. I also saw in my research it could be the thermostat, the door latch, and/or the control button board. I bought all four parts to be safe. I replaced the main board and the DW did exactly the same thing. As I was swapping the original board back in, I noticed the white pair of wires going into the door latch were darkened. I moved the four wires going into the door latch and noticed the plastic connectors plugged into the latch made a crunching noise when wiggled. I took the latch off and found the wires and white plastic connectors to the latch were burnt and melted in places. Obviously, there was a short. I used the new latch part kit to fix the issue. The kit comes with new wire terminals and heat-shrink insulation. I cut off the original, burnt wire connectors, and a bit of darkened wire, crimped on the new terminals, used a heat gun to put on the insulation and reassembled the DW door. That solved it and the DW is operating normally. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers
Dean B Colfax , CA June 22, 2020 Electromechanical latch broke Ordered the part and watched the video on Appliancepartspros.com. Easy disassembly but found it difficult to align the control panel and the door face while screwing together. It helped to have a second pair of hands. Job turn out great. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers