Emily H Sun City , AZ January 23, 2018 Range controller ailed rapidly flashing ordered replacement. Pull range out. Disconnect power cord. Remove 6 screws from top back panel Remove 4 screws from controller Disconnect 3 electrical connectors. (They Are distinctive and cannot be confused). Hook the connectors to the new unit. Refasten with the 4 screws and place The schematic ( self adhesive) Reinstall back top panel with the 6 screws Reconnect to power. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Joe G Corpus Christi , TX September 21, 2019 The oven control burned out. Just unscrewed upper back panel with a 1/4 inch nutdriver,Then I took off 4 screws on the oven control, unplugged the control then replaced part 3. make sure you put the face of the control on before you install it by the way make sure you unplug your range before you do anything. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Steven J Virginia Beach , VA June 04, 2019 Controller card burnt up. I bought a new controller card and film and replaced it in about 5 minutes with a screwdriver and nut driver. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Jared V Oshkosh , WI January 06, 2019 Appliance: Frigidaire Electric Range FGEF3032MFF F10 error code after power outage Ordered the overlay and controller for oven after determining they had shorted out due to power surge. Parts arrived fast and replacing them on the oven took 15-20 minutes. Very simple, anyone with basic "fix-it" knowledge could do this. Very satisfied with purchase Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Elizabeth H Lumberton , MS March 11, 2019 Control board Replacement Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes